Please Select Your Location
Australia
Österreich
België
Canada
Canada - Français
中国
Česká republika
Denmark
Deutschland
France
HongKong
Iceland
Ireland
Italia
日本
Korea
Latvija
Lietuva
Lëtzebuerg
Malta
المملكة العربية السعودية (Arabic)
Nederland
New Zealand
Norge
Polska
Portugal
Russia
Saudi Arabia
Southeast Asia
España
Suisse
Suomi
Sverige
台灣
Ukraine
United Kingdom
United States
Please Select Your Location
België
Česká republika
Denmark
Iceland
Ireland
Italia
Latvija
Lietuva
Lëtzebuerg
Malta
Nederland
Norge
Polska
Portugal
España
Suisse
Suomi
Sverige

How do I reassemble the headset after repair?

After receiving your repaired headset, properly attach the accessories before using your headset again.
  • Reconnect the headset cable.
    1. Press and hold the lens distance button on the headset, and then pull out the visor to its farthest point. For an easier access to the connector slots, pull up the headset strap.
    2. Align and reinsert the headset cable connector (side with round mark up) to the port with the corresponding round mark. You'll hear a click when the connector is fully inserted.
    3. Press and hold the lens distance button on the headset, and then push the visor back to the starting point.
    4. Make sure that the headset cable connector is secured and that the cable is set before the edge of the compartment.
    5. Loop the cable around the band of the strap next to it. The stopper on the headset cable should be positioned before the ridge. Make sure that the headset cable passes through the ridge and the cable clip at the back of the headset.
  • Replace the compartment cover. Align the tabs on the cover with the holes on the compartment, and then push the cover until it snaps in place.
  • Reattach the face cushion. Insert the tab on the face cushion into the slot on the headset, and then align the hook and loop strips.
Submit
Thank you! Your feedback helps others to see the most helpful information.