Pairing and calibrating VIVE Wrist Tracker

To get the most out of VIVE Wrist Tracker, it must be calibrated after pairing.

Make sure you're wearing your headset and wrist trackers before performing the following steps.

In VIVE Focus 3, go to Settings > Inputs > Controllers.
Select the input type button "‍"‍ in the upper right to switch the controller input to the trackers.
The Unpair controllers screen will appear.
Select Continue to unpair the controllers and turn on hand tracking.
The Pair wrist trackers screen will appear.
Place the controllers aside on a flat surface.
Press the Power button on the trackers to power them on.
Press and hold the Power button again for 2 seconds to initiate pairing mode. Both LEDs will first blink blue, and then the status LED corresponding to the tracker you're pairing will turn solid green.

When both trackers are paired, the Calibrate trackers screen will appear. If you're only pairing one tracker, select Skip after the tracker is paired to continue.
Select Calibrate and follow the onscreen instructions. When the trackers have been successfully calibrated, the screen will close, and you'll be back in the Lobby.
Tip:
- Select I'm not using it for hand tracking if you intend to use one of the wrist trackers for object tracking.
- If your trackers are paired on the wrong side, you can swap them by pressing the Power and App buttons at the same time.

Was this helpful? Yes No

Submit

Thank you! Your feedback helps others to see the most helpful information.