Pairing and calibrating VIVE Wrist Tracker
Make sure you're wearing your headset and wrist trackers before performing the following steps.
- In VIVE Focus 3, go to .
Select the input type button "" in the upper right to switch the controller input to the trackers.
The Unpair controllers screen will appear.
Continue to unpair the controllers and turn on hand tracking.
The Pair wrist trackers screen will appear.
- Place the controllers aside on a flat surface.
- Press the button on the trackers to power them on.
Press and hold the
button again for 2 seconds to initiate pairing mode. Both LEDs will first blink blue, and then the status LED corresponding to the tracker you're pairing will turn solid green.
When both trackers are paired, the Calibrate trackers screen will appear. If you're only pairing one tracker, select Skip after the tracker is paired to continue.
Calibrate and follow the onscreen instructions. When the trackers have been successfully calibrated, the screen will close, and you'll be back in the Lobby.
Select I'm not using it for hand tracking if you intend to use one of the wrist trackers for object tracking.
If your trackers are paired on the wrong side, you can swap them by pressing theand buttons at the same time.